Took the bike for a spin the other night and noticed something odd. When the bike goes up hill it bogs down and will only rev to 1k but when it goes down hill it rev's by it's self to 13-14k?
Could this be a float bowl problem as this is all I can think is moving?. I cleaned the bowl filter's when I was re-building the bike could I have up-set the needle's?
Gravity Problems
Moderator: Moderators
- Miles
- zxr400 oc member
- Posts: 505
- Joined: Wed Apr 30, 2008 11:00 pm
- My Bike: ZXR 400 L3
- Location: Bangor, Northern Ireland
- Mad Phil
- Posts: 91
- Joined: Wed Jun 24, 2009 6:39 pm
- My Bike: Hayabusa, Ducati 996SPS
- Location: Stoney Stanton, Leicestershire
Re: Gravity Problems
It revs to 1K ??
The tickover must be 1250rpm ish. So it revs to below tickover ?
Do you mean 10K...?
Is it restricted to 33bhp?

The tickover must be 1250rpm ish. So it revs to below tickover ?

Do you mean 10K...?
Is it restricted to 33bhp?
- RedexRobB
- Site Admin
- Posts: 7212
- Joined: Fri Aug 30, 2002 7:37 pm
- My Bike: ZXR400L3
- Location: Ipswich, Suffolk
Re: Gravity Problems
you can check the float levels by putting a long, clear piece of pipe on the carb drain outlets and opening the drain screw. Then route the pipe to just beside the RHS of the carbs and theres a line marking on there telling you where the fuel should be.
- Miles
- zxr400 oc member
- Posts: 505
- Joined: Wed Apr 30, 2008 11:00 pm
- My Bike: ZXR 400 L3
- Location: Bangor, Northern Ireland
Re: Gravity Problems
No I mean 1k she bogs to below tick over and will cut out if i dont hold the throttle fully open.
She is un-restricted
She is un-restricted
- Vard66
- zxr400 oc member
- Posts: 823
- Joined: Tue Apr 22, 2008 3:07 am
- My Bike: Coming soon; hopefully...
- Location: Swindon Area, Wiltshire.
Re: Gravity Problems
Is the idle speed really that high?
I've been setting mine to about 850ish, it's no wonder it feels pretty lumpy at that.
I've been setting mine to about 850ish, it's no wonder it feels pretty lumpy at that.
- RedexRobB
- Site Admin
- Posts: 7212
- Joined: Fri Aug 30, 2002 7:37 pm
- My Bike: ZXR400L3
- Location: Ipswich, Suffolk
Re: Gravity Problems
tickover should be at 1250rpm. Probably find your getting quitre a bit of engine braking too id imagine lol Might be why you have a problem starting it vard?
- Vard66
- zxr400 oc member
- Posts: 823
- Joined: Tue Apr 22, 2008 3:07 am
- My Bike: Coming soon; hopefully...
- Location: Swindon Area, Wiltshire.