www.zxrworld.co.uk

Hi all ive been told by a local shop that my carbs are out of balance and im unsure how to correct them.
My dads got the kit which you use to do the job but i duno how to use it
any help please
mike

You need some VAC gauges.

See the guide here:

http://www.zxrworld.co.uk/zxr400/balancing.html

cheerz for that
as soon as the weather cheers up ill have a little fiddle

I balanced my carbs using the guide posted above, very easy to do.

Hi
I am balancing carbs too but my carbs working on 1200 rpm on -2.20bar.
In manual wrote -2,70 bar.How I cann puting my carbs on that number?

Hi im from middlesbrough area any one local wanna borrow me some vacum gauges??

bato wrote:Hi
I am balancing carbs too but my carbs working on 1200 rpm on -2.20bar.
In manual wrote -2,70 bar.How I cann puting my carbs on that number?

Bato, that number referes to the difference in the vacuum pressure between the cylinders. Basically the pressure doesnt matter when balancing, they just have to be all the same.

hi

I am cleaning my carbs ,change needles and on the table I control carbs.Carbs is ok controle with presure from few hours on the table is ok dasnt licking.
But when the carbs are on the bike and bike working after I note litle licking from 4 carb an the buterfly and engine start only with some trotle.
Why that licking start.The carbs are balancing and I put pilot screw 2,1/4 2,1/2 the same results?
I change rubbers on the needle valve and float high is on the maximum 13mm.
Why that nightmare comes?
Finaly I think there is some gremlin in my 4 carb and he push fuel on the buterfly

i take it you mean a clicking sound sound when you open the throttle?

perhaps you have reassmbled wrong?

I cant understand this.
I must opening butterflys with throttle when starting engine because 4 carb is dry (I think)

You must have put something together wrong bato. Get the carbs apart again and double check everything.

I must by the gun and killing little gremlin.
I cant understand on the table everything is ok but on the bike licking.

whats licking?

fuel is on the butterfly

leaking!!??

You must have set something wrong bato when you put it back together. Check with the manual and see if you can find anything you have done wrong with setting the float height.

http://www.zxrworld.co.uk/Manuals/H%20M ... er%202.pdf

check page 2-8