www.zxrworld.co.uk

Hello,

I have just got my carbs balenced and i want to check the fueling is set to what the manual says. I have been through the hole manual and have seen on the diagrams where the pilot screw is located on the carbs but I cant for the life of me find them on my actual carbs Can anyone point me in the right direction as obviously I am haveing an extremely blonde moment! Maybe is it just hidden from view?

Any advice would be greatly appreciated,

Thank you!

Leanne

if the carbs are still on the bike, then you will find the screws are upside down. They each sit in a tube at the back of the float bowl(closer to the engine side). They are harder still to see because of the heater circuit. You need a short screwy to get at them.

Thanks Andy!

All sorted now the bike runs like a dream I am over the moon

Leanne