Page 1 of 1
Dynojet slide drill
Posted: Mon Jan 10, 2011 9:36 pm
by Davide
Hi, can someone please tell me the diameter of the slide dril supplied in the Dynojet stage 1?
I've bought a nice used kit but is without the slide drill...
Thanks
Re: Dynojet slide drill
Posted: Tue Jan 11, 2011 1:03 am
by gavinfdavies
cheat... email dyno jet and say you've lost it! failing that, the drill for my cvk32's was 5.5mm i think (this kit was NOT for the ZXR!), which was just big enough to take the hole up to fill that available space if that makes sense. doesn't does it? sorry !
Re: Dynojet slide drill
Posted: Tue Jan 11, 2011 9:06 pm
by Davide
Thanks, I've sent and email to the Dynojet tech Support
Re: Dynojet slide drill
Posted: Sun Jan 16, 2011 10:04 pm
by Davide
Hi, Dynojet says.......the hole must be enlarge until 3mm.
It's a 3mm drill
Re: Dynojet slide drill
Posted: Mon Jan 17, 2011 11:43 pm
by gavinfdavies
wow, that's tiny, that said each carb is only flowing enough air/fuel for about 15bhp each, whereas the ones on my gpz are flowing about 25-30 per carb.