Page 1 of 1
Shims
Posted: Tue Jun 29, 2010 4:11 pm
by wes
After searching I see that someone recommended using shims from Elite MX & Quads, but when I measure my shims they are 7.42 diameter and the ones from Elite are 7.48...a gnats bigger.
Has anyone here used these as they are a fair bit cheaper?
Cheers
Wes
Re: Shims
Posted: Tue Jun 29, 2010 11:41 pm
by extonyg
the shims for my L1 are 7.48mm and i brought a kit of all sizes off ebay so i have a collection for doing them again.
Re: Shims
Posted: Tue Jun 29, 2010 11:59 pm
by Fatspanner #44
wes wrote:After searching I see that someone recommended using shims from Elite MX & Quads, but when I measure my shims they are 7.42 diameter and the ones from Elite are 7.48...a gnats bigger.
Has anyone here used these as they are a fair bit cheaper?
Cheers
Wes
Hi Wes. Sent you a PM but not sure if it sent. The 7.48mm are fine for the ZXR400 and it may well be that the ones you had were just a wee bit smaller than the norm as a few engineers make their own.
Cheers
Colin