i basically want to rant about car drivers being sh i t.
smacked up the backside
Moderator: Moderators
-
guitarcarrot
- Posts: 85
- Joined: Sun Nov 13, 2011 10:02 pm
- My Bike: ZXR 400 L2
- Location: Bromley
smacked up the backside
i got smacked up the butt this evening by some shitty 4wheel driver, in contact for a second or two as he shunted me down the road i had my gf on the back, driving sensibly and what do i get? makes you want to speed doesnt it -__- i didnt actually go down, but the car ate my numberplate and blinkers, it was comletely orignal and now its not
sad times
i basically want to rant about car drivers being sh i t.
i basically want to rant about car drivers being sh i t.
- Mori Man
- Blingmeister

- Posts: 1976
- Joined: Thu May 10, 2007 3:30 pm
- My Bike: ZXR400J2
- Location: JAPAN
Re: smacked up the backside
Hope you got their details !
You want to have your rear axle, bearings and cush drive checked along with your swingarm shaft & bearings - all have just been stressed in a shunt.
Good to hear you & GF are well though
MM!
You want to have your rear axle, bearings and cush drive checked along with your swingarm shaft & bearings - all have just been stressed in a shunt.
Good to hear you & GF are well though
MM!
Nothing worse than having an H and not being able to scratch it !
Living life on the edge, SuPposedly
Living life on the edge, SuPposedly
-
guitarcarrot
- Posts: 85
- Joined: Sun Nov 13, 2011 10:02 pm
- My Bike: ZXR 400 L2
- Location: Bromley
Re: smacked up the backside
Yeah I got his plate, just a matter of "sorting him out" now aha, but yeah I'm going to wait till end of january and the once exams at school are over, drop the block and swingarm off, I want to put a zx6r shock in, clean up the block, valve clearances, maybe new chain and sprockets if the wallet allows it, also is there a sort of centre stand type thing that goes through the holes in the middle of the frame? That would make maintainance much easily
cheers, Tony