www.zxrworld.co.uk

Hi ,
would it be possible to use the hoover tubes as ram air ,if you slightly moded them?

Like if they were the same diameter entering the original air box as they are where they are mounted to the fairing.

If the snorkel was blanked off,

surly this would pressurize the air box a bit.....?? or no?

Any thoughts??

like look at these tubes on this ,

Think I'm going to paint my bike same scheme as this,with the y spoke wheels might be nice.

Im the only one replying to my threads??

see the angle of the hoses is not that steep ...air should flow freely ....

Im just waiting to be shot down like a lame badgor!

How far into the airbox do they go?

I don't know,it's hard to see through the cover on the airbox.

Cant really do it on the H, because of the tank. You can do it on the L no probs.
On my h, i moulded a snorkle and stuck it to the front of the airbox and ran it over the rad as usual.. can result in setting up difficulties with air pressure because the carbs are outside of the box... i got mine working ok...
But, i only did it cos i had probs getting a h box. You can get them now.
Do yrself a favour and spend 200 quid on a airbox and bellmouth kit.

i have a carbon fiber tank cover with a fuel cell,
where are they available now?

Dynopro racing in runcorn used to make all my stuff.
They did have a kit copy mould for the H, but i havent raced a H for a few years now. They would be my first call.
Then try rmkd maybee... not sure if he ever played with the H model tho..
AMS used to do a few bits... but again he has gone minitwins like most.
Does anyone in your club have a H box you could get a mould off?

not in a club ,
just building this for a few track days and to keep sane a little.