www.zxrworld.co.uk

So yeah, that micron zorst arrived. Mint condition down pipes dont look bent.

looking at the front of the bike and starting from the left,

#1 #2 and #3 fit nicely into the collector but #4 is being an absolute pikey and wont sit flush causing the end can to be out of line with the hanger.

Am i going to need a rubber mallet?

I had a friend help with mine and we managed to pull the outer two pipes out and slot them in, then a little bit of pushing on them as we bolted and they're all in fine. Getting the old ones out was the hardest part I found!

Also not sure how your system is, but I fitted the downpipes alone then the slip on after they were in place.