Page 1 of 1
vfr400 nc30/35 swingarm
Posted: Sun Dec 09, 2012 2:11 pm
by kingkenny
i am looking at building a zxr special and im think about fitting nc30/35 single side swing arm i was wondering if this has been done before and how much work is it to fit
Re: vfr400 nc30/35 swingarm
Posted: Sun Dec 09, 2012 7:11 pm
by banner001
think it might have been done before...expect it to be a MASSIVE amount of work.
if you cant strip and rebuild an engine, dont even think about doing it.
dont expect to get exact specs on here about exactly what/how to do everything...its too specialised a job, but expect to look at relocating the rear brake, suspension, aligning the sprockets, correctly centering the wheel along the length of the bike, checking ride height etc...