www.zxrworld.co.uk

Hi im wanting to change the bar end protectors on my bike and they just wont seem to budge, :smt013
are they removable or part of the bars themselves?
if they are removable how??

Thx lol

The standard bars are a single piece of (solid, thanks RobB) Ally bar. There are no bar end weights on the standard bars. That'd be why you can't get them off!

I think some people have fitted ZX-6R bars, which do allow you to change the bar ends.

are you sure they're solid Deviant

Cheers better stop trying to force them off then lol

masterofinsanity wrote:are you sure they're solid Deviant

quite sure, seen the photographic evidence.

and you're in no position to take the piss, I seem to remember you thought they'd be hollow as well

And heres the evidence





ZX6R clip-ons will fit the 400, zxr400er had them fitted to his and put on some shitty anodised bar ends on.

what a waste of a bar end RobB you should be ashamed, that could have been used for the zxrworld bike build.

RobB wrote: ZX6R clip-ons will fit the 400, zxr400er had them fitted to his and put on some shitty anodised bar ends on.

oh i miss zxr400er. you two with your handbags out was great entertainment

That handle bar proved a point, and it had a huge chunk off the end of it anyway

Wow cheers for the pics drastic but looked fun ..

ah thats right thoe ppl will do anything to prove a point.

sorry to drag up an old thread but anybody know what age zx6r clip ons can be used? and whether or not the switchgear can be as well?
cheers
dan

Not sure what year, i seem to remember the ones ZXR400er used were off a ZX6R F model or something like that. You can use the standard switch gear, you just might need to drill holes for the locating pins in the switchgear.

you will be able to use the 6r ones but you'll need to start cutting into the loom so up to you!

The zxr750 ones 'might' fit but i've got a feeling that the fork legs are biger

The ZXR400 switchgear fits straight into the bars as far as i aware, if not then its simply a case of drilling a locating hole for the pin to stop it spinning on the bar. So why would you need to hack into the loom?