O Rings in the inlet rubbers

Welcome to the ZXRworld forum.

Moderator: Moderators

Post Reply

When replacing the inlet rubbers on the later models, do people...

Replace the O rings, no sealant
0
No votes
Replace the O rings, use sealant
2
50%
keep the old rings in, use sealant
2
50%
take the old rings out, have no rings, and use just sealant
0
No votes
 
Total votes: 4
User avatar
RedexRobB
Site Admin
Site Admin
Posts: 7212
Joined: Fri Aug 30, 2002 7:37 pm
My Bike: ZXR400L3
Location: Ipswich, Suffolk

Re: O Rings in the inlet rubbers

Post by RedexRobB »

:smt017

Are the needle rubbers up top of the carbs all ok? not perished or split? Properly seated etc?
Top
stug
Posts: 139
Joined: Sun Nov 30, 2008 1:03 pm
My Bike: Yamaha R1

Re: O Rings in the inlet rubbers

Post by stug »

Had the same problem with my wifes after rebuilding the carbs and doing the shims.
The last thing that I replaced and it sorted the problem was the mixture screws.
One looked like it had a slight bend near the tip.
Although this could probably have been fixed by messing about with the screws.
Top
Post Reply

Return to “Free For All”