Any more Aussies on here ?

[sharky]

Just wondered if there were any ?
If so are there any 400 wreckers/importers that you use ?

[masterofinsanity]

used to be a guy from new zealand on here Kiwi but he aint been on for ages.

[tk400]

Yeah ..How areyou goin, I am in NSW. What bits are you lookin for. I have a fair bit of gear. cheers

regards TK400

[sharky]

Hi Tk,
I am looking for a frame..ideally a very cheap stat write off to start with....want to measure up and see how easy/tricky fitting a zzr6 motor will be.
I have the remains of a zzr frame so I do an easy comparision. Tried 'Findapart' but no luck as yet.

[tk400]

Hey sharky, I have a zxr400 L model frame that Is slightly bent but would be an easy repair if you were going to take off the engine mounts and reweld them in a different location, As the frame is much easier to pull when thoseare off. I have had 2 frames worse than this repaired before. If your interested Ill take some photo's for you. I was going to keep it and do a 636 conversion on that frame.....cheers

Regards TK400

[sharky]

Certainly am mate....pICS AND HOW MUCH

[tk400]

LOL....I have the same reaction when I find parts for 400's in Australia....
PM me your Email and I will send you some pics...Have you got a size limit on your inbox......cheers

regards TK400

[sharky]

Pm sent mate. I have an old stat write off zzr6 frame so the plan is to graft the engine mount brackets from that....hopefully......I think.....Luckily I know a good custom frame builder (one of the ASF blokes)

[sharky]

Did you get the pm's Tk400 ?

[sharky]

Have you had a chance to get any pics mate ???

[tk400]

Sorry mate. I have taken the pics just been a bit busy. Will check it out now and send em off to you...cheers mate