1mm oversize pistons

[fatboy]

1mm oversize pistons,Has any one got any advise on which make to use . they are for my race engine .need them to hold together upto 15800 revs . many thanks Roy

[simon_ed]

i've got JE 1mm oversize pistons in my main engine, i think they will re bore your barrells too. the engine mine are in were revved to 16,100 but then taken down to 15,500, but i think it's revving to 15,000 now.

but JE pistons would be the way to go

[Robbie]

Stick with std pistons.easier to get replacement and a lot less costly.1mm dont give that much increase and you cant rev them as hard.Just get a decent tuner [RMKD]

[fatboy]

Thanks for the advise Robbie but i tune my own engines . and i am after more drive from lower revs . my engines are reving 16+ with std in 2. and 15900 +5 in the other. i just needed some advise from those who have experience with 1mm pistons many thanks Roy

[Robbie]

cost factor vs increase ive been told by a reliable source it just aint worth it but hey each to there own.

[simon_ed]

Thanks for the advise Robbie but i tune my own engines . and i am after more drive from lower revs . my engines are reving 16+ with std in 2. and 15900 +5 in the other. i just needed some advise from those who have experience with 1mm pistons many thanks Roy

buy an RVF if your after something that pulls from lower revs

[AFM327]

Toecutter on this board had 1mm over omega pistons, they're very very nice. I haven't been able to get in touch with him but I'm in the US. You might contact Omega, since he had them custom made there. No replacement for displacement. I was hoping to get 2mm over from Rob but wasn't able to work it out. I may try contacting Omega myself about a set.