starting

Moderator: Moderators

Post Reply
ferrarikid
Posts: 11
Joined: Sun Jan 27, 2008 2:19 pm
My Bike: KR1S
Location: southampton

starting

Post by ferrarikid »

I've just changed the frame on my bike, now the damn thing won't start. Was ok before hand managed to get it going once but didn't sound right and smelt really hot.Today it sparked once and then gave a loud backfire due to fuel build up, The rev counter is going up to 3000 revs when turning over and the fuse box is getting really hot??? any ideas?
The frame has been painted black but i've scraped some paint off for the earth.
User avatar
masterofinsanity
Site Admin
Site Admin
Posts: 8111
Joined: Thu Aug 29, 2002 12:36 am
My Bike: Aprilia Tuono Fighter
Location: England
Contact:

Re: starting

Post by masterofinsanity »

is the battery any good, sounds like somethings shorting.
Don't forget people there is more to the zxr400 than this forum... check out www.zxrworld.co.uk also.
ferrarikid
Posts: 11
Joined: Sun Jan 27, 2008 2:19 pm
My Bike: KR1S
Location: southampton

Re: starting

Post by ferrarikid »

I think i've sourced the problem, on removing the top yoke i gave the ignition switch a few gentle taps to get the yoke off, i've had the switch apart and found there is a small resistor in there that goes across to the grey wire( the one that goes to the cdi) this had come loose on one side as it wasn't soldered on that well.
Now that it's back as it should be i've got a spark. Just waiting for the battery to recharge to see if it will start. :smt003
ferrarikid
Posts: 11
Joined: Sun Jan 27, 2008 2:19 pm
My Bike: KR1S
Location: southampton

Re: starting

Post by ferrarikid »

Problem sorted, took plugs out and blasted them with my gas soldering iron(has a flame tip on it) lots of popping from the plugs as the fuel must get trapped in them as they're so long. put them back in and it fired straight away!!! :smt003
Post Reply