vfr400 nc30/35 swingarm
Moderator: Moderators
-
- Posts: 2
- Joined: Mon Aug 06, 2012 9:47 pm
- My Bike: zxr 400 l
vfr400 nc30/35 swingarm
i am looking at building a zxr special and im think about fitting nc30/35 single side swing arm i was wondering if this has been done before and how much work is it to fit
- banner001
- Track day God
- Posts: 2589
- Joined: Sat Sep 24, 2011 3:27 pm
- My Bike: ZXR400 L4
- Location: Nuneaton
Re: vfr400 nc30/35 swingarm
think it might have been done before...expect it to be a MASSIVE amount of work.
if you cant strip and rebuild an engine, dont even think about doing it.
dont expect to get exact specs on here about exactly what/how to do everything...its too specialised a job, but expect to look at relocating the rear brake, suspension, aligning the sprockets, correctly centering the wheel along the length of the bike, checking ride height etc...
if you cant strip and rebuild an engine, dont even think about doing it.
dont expect to get exact specs on here about exactly what/how to do everything...its too specialised a job, but expect to look at relocating the rear brake, suspension, aligning the sprockets, correctly centering the wheel along the length of the bike, checking ride height etc...
UK ZXR400 L3 (1993) - Fully restored and on the roads, my green beast!
JPN ZXR250 A2 (1990) - Revs to 19,200rpm... 'nuff said
JPN ZXR250 A2 (1990) - Revs to 19,200rpm... 'nuff said