clutches
Moderator: Moderators
-
- L-plate hell
- Posts: 363
- Joined: Sun Dec 23, 2007 10:09 pm
- My Bike: zxr400l4 zx7r
- Location: the shire of essex
clutches
a mate is having problems with his clutch. basicaly its as though its still biting when the lever is pulled in. tried adjusting it at the lever but the thread is knackered and the cable isnt even sitting in it properly. weve adjusted it at the engine end to no avail. the cable is only about 2 months old so hasnt had much use due to shitty weather. does it need a new lever assembly or clutch? if it is a clutch, how difficult are they to change and what is needed (plates, springs etc)?
anything is possible with enough time and money. and an open mind...
-
- zxr400 oc member
- Posts: 3341
- Joined: Sat Jan 08, 2005 10:33 am
- My Bike: tomos moped
- Location: Carrickfergus Northern Ireland
Re: clutches
Sounds like it's not lifting properly
Get the external bits working properly before you go delving into the clutch itself
Knackered threads doesn't sound good
Cable not "sitting in" properly doesn't exactly insipre condifence
If it is plate or springs it's a relatively easy job to replace them
Get the external bits working properly before you go delving into the clutch itself
Knackered threads doesn't sound good
Cable not "sitting in" properly doesn't exactly insipre condifence
If it is plate or springs it's a relatively easy job to replace them