Carb heater fitting

Moderator: Moderators

Post Reply
Posts: 3
Joined: Sun Nov 27, 2016 1:23 pm

Carb heater fitting

Post by namtabmai » Mon May 14, 2018 8:49 am

Without going into details of what ham fisted ape did what, I've found myself with a carb heater fitting which has one of the plastic arms broken.

I've read that people have removed these but I'd like to at least have a stab at getting them working again before going that route.

Am I right in thinking this is part 92005B-1291? Because it looks like like SOL unless I want to spend £40 getting one from America.

Think I could get away with using epoxy to repair it?

User avatar
Track day God
Track day God
Posts: 2496
Joined: Sat Sep 24, 2011 3:27 pm
My Bike: ZXR400 L4
Location: Nuneaton

Re: Carb heater fitting

Post by banner001 » Mon May 14, 2018 2:29 pm

If it's the angled bit that physically goes into the carb, then yes, that will come with new o rings as well
UK ZXR400 L3 (1993) - Fully restored and on the roads, my green beast!
JPN ZXR250 A2 (1990) - Revs to 19,200rpm... 'nuff said :smt003

Post Reply